horizontal rule

1970 Hot Wheels
US - Snake Funny Car (6409)

US Casting Menu - Bodies
1970 History Intro Cars Bodies Chassis Misc HK

Type Click Photo to Enlarge US Snake Funny Car - Bodies
Items in Red show changes from previous version
Prototype
0

#2

Prototype

Part # 6409 0500
  • Name: None
  • Part # location: Driver front
  • Cavity # location: Driver front
  • Revision: None
  • Revision Location: None
  • Door, Hood & Truck lines : Very thin
  • Interior supports: None
  • Rear window support tab: Very small
  • Rear lift post to clamps: Open
  • Tool #s 1, 2

  • Car Usage: 1st Prototype
Compare 0 & A versions
Production
A

#5

SNAKE

Part # 6409-050 B
  • Name: SNAKE
  • Part # location: Both sides underneath the roof
  • Cavity # location: Driver front
  • Revision: B
  • Revision Location: Passenger rear underneath trunk lid
  • Door, Hood & Truck lines : Thick & Wide
  • Interior supports: One on each side of rear window
  • Rear window support tab: Large
  • Rear lift post to clamps: Attached
  • Tool #s 1 - 6 (1,2,3,5 seen)

  • Car Usage: All
A

#2


US Snake Funny Car - Common Body Details
All
  • info
  • Bodies came from two Tools, while there are several differences on all sides, to tell them apart from the outside it's easiest to .....
Tool #1 - USA
  • info
Tool #2 - USA
  • info
  • Greater than 90% of the Bodies are Type B, with the Hatch Stop Block.

horizontal rule

Home   |   FAQ   |   Site Map   |   Links   |   Sell-Trade   |     |   Search

Copyright © 2015  www.HWRedlines.com  All rights reserved.
The pictures and descriptions on this site may not be reused without obtaining prior permission.
Hot Wheels are a registered Trademark of Mattel Inc.  This site is not affiliated with Mattel Inc. in any way.